What are the components of industrial waste gas in life? Waste gas treatment equipment includes organic waste gas purification treatment system and inorganic waste gas purification treatment equipment. Organic waste gas mainly includes high quality Catalytic combustion equipment Hydrocarbons, aromatic hydrocarbons, alcohols, aldehydes, acids, ketones and amines, etc. Inorganic waste gas mainly contains sulfur and oxygen Catalytic combustion equipment manufactor Chemicals, nitrogen oxides, carbon oxides, halogens and their compounds, etc.: 1. Waste gas purification in the paint spraying workshop, paint baking workshop, and paint spraying workshop: benzene waste gas treatment, toluene waste gas treatment, xylene waste gas treatment, TVOC waste gas treatment, paint mist particles, etc.

Is it difficult to manage the waste gas of electronic industry? Electronic industry is the primary industry of VOCs emission. There are many kinds of VOCs emission from electronic industry, and the components are disordered. The air volume in exhaust gas emission is large, and the VOCs concentration is low. The organic waste gas in the semiconductor process has the characteristics of large emission flow. The circuit board adopts the cleaning free process and promotes the use of cleaning free flux. The production operation of electronic surface painting is replaced by the traditional air painting process by the electrostatic painting process, and the organic solvent free or low content organic solvent paint is used.

In order to ensure the normal operation of the dedusting system and avoid environmental pollution again, the dust collected by the deduster should be properly treated. The treatment principle is to reduce the secondary dust, protect the environment and recover for use, turn harm into benefit, turn waste into treasure, and improve economic benefits. According to the production process conditions, dust nature, recycling value, and the amount of dust to be treated and other factors, on-site recycling, centralized recycling and centralized waste can be selected. How to deal with noise and coal mine dust in workshop? Coal mine dust is produced by various coal particles and rock particles in the process of coal production.

It is suitable for painting, printing, adhesive and other occasions where the temperature is not high, the humidity is not high, and the exhaust volume is large, especially for the purification and recovery of halides. 2. UV photolysis UV photolysis technology is to use special ultraviolet wave band to break the injection molding waste gas molecules, break their molecular chains, together, decompose the water and oxygen in the air to make them become highly active ozone or free hydroxyl, and then oxidize the waste gas molecules to generate water and carbon dioxide. The participation of catalyst can improve the reaction rate and the efficiency of treating injection molding waste gas, and then achieve the goal of purifying waste gas.

The waste gas is qualified and discharged high above the chimney. The manufacturer introduces the concept and characteristics of biological treatment of organic waste gas. 1. The concept of biological treatment of organic waste gas. Biological purification of organic waste gas is developed on the basis of mature selection of microorganisms to treat wastewater. Biological purification is essentially an oxidation and decomposition process: attached to porous The active microorganisms on the wet medium take the organic components in the exhaust gas as the power or nutrition of their life activities, and convert them into simple inorganic substances (CO2, H20) or cell components.